Tim, i hope you are handy with a soldering iron. I would start looking at the capacitors on your power board. It sounds like you have a few that might need replacing. It is also possible that a mosfet on your board has failed. You can download the service manual from here Check your power board and see if your caps are either leaking (sticky oil like substance on the PCB) or if the tops are bulging. Those are the once to replace. Parts are available at places like this if you want to replace the board. Your caps can be purchased inexpensively at places like Mouser.com and Digikey.com Of course, make sure that you read and follow the safety precaution when and if you decide to work on your TV. Hope this helps, good Luck
I had this sort of issue as well, after I've had the %#*@ thing for about 2 yrs-working with no problems!! I did change the Settings from "Borderless" to "with Border", also changed Paper Type to "MATTE", and make sure Document Size is on "LETTER"..and it worked!! It will NOW COPY-SHORT JOY.....bcz the ADF will NOT WORK !!! I need to be able to throw a STACK of Docs in there to Either COPY or SCAN....ADF NOT Cooperating!!!!!!!!
Been playing GTA V PC since the launch, running solid 120 FPS on high settings, but recently, a few days after that I started to record GTA V with OBS 60 FPS the game has started lagging so I cannot even record anymore, barely able to run 70 FPS on the lowest possible settings. My rig should be way enough to run all this.
My Connect won't 'boot' and does not show up in the controller's list
My Connect was working perfectly but then dropped off the controller list of 'rooms' or 'zones'. The white light was not showing.
I have tried to reboot it by switching off for several minutes but when I switch it back on the white light comes on for approximately 4 seconds then goes off. No other colour lights show. I have tried the 'reset' (switch on whilst holding mute button) but it still shows the white light for 4 seconds then goes out.
I have tried with my other Sonos speakers all switch off, with the unit connected via ethernet and without, with a speaker connected via ethernet etc but no change. The unit still gets just as hot and the optical port has a red light inside and the ethernet ports both seem active when plugged in (green and orange lights)
We have a chance to guarantee our right to repair electronic
equipment—like smartphones, computers, and even farm equipment. This is a once-in-a-generation
chance to protect local repair jobs—the corner mom-and-pop repair shops that
keep getting squeezed out by manufacturers.
Join the cause and tell your state representative to support Right to Repair. Tell them you believe repair should be fair, affordable, and accessible. Stand up for your right to repair!